Choose from the following luxury Egger finishes

Light Grey Chicago Concrete - a cool-looking concrete surface with Smoothtouch Matt surface texture creating a matching cool matt feel.
White Chromix - a metallic, concrete look with Deepskin Rough surface texture reproducing the rough feel of the material.
Sand Beige - a red beige tone that looks warm but natural against wood. Smoothtouch Matt gives a modern matt look and feel.
White Levanto Marble - a discreet, elegant marbling pattern which provides a natural appearance. Finished in a smooth matt touch.
Scivaro Slate - combines elegance and rough naturalness, and can be a high-quality alternative to concrete.
Cupria Slate - warm, elegant and natural. The copper-coloured base refines this black stone which combines well with bronze, copper or red wood tones.
Dark Grey Chicago Concrete - a warm concrete well suited to combinations with white and natural woodgrain decors.
Black Pietra Grigia - a striking character with white veins and a Smoothtouch Matt finish which create a matching cool matt feel.
Alpine White - the most neutral white, it's high opacity and the Smoothtouch Matt surface texture give it an additional high value
Cobra Bronze - a natural yet graphic look that catches the eye with metallic effect feel.

Fitting Instructions for Floating Unit with Electric Fire

Note: These instructions assume you already have a socket in place for your fire behind the central section of your unit.

Tools & Materials Required:
• Stud finder (for stud wall installations)
• Spirit level
• Tape measure
• Pencil
• Screwdriver or drill driver
• Helper (recommended for lifting and holding unit)

This unit comes with our EasyHang rail system and all necessary fixings for stud walls included.

1. Locate your studs — ideally at three separate points where the hanging rail can be fixed.

2. Position the rail so it’s level, then fix it to the wall using the wood screws and washers provided. Make sure the middle section sits flush against the wall.

3. With the help of another person, lift the unit onto the rail so that the clips catch securely.

4. From inside the unit, tighten the clip screws to lock it in place. At this stage, you can make small adjustments to ensure the unit is perfectly level.

5. For extra stability, we recommend adding a couple of additional screws through the back of the bottom panel — the section that sits flush against the wall behind your fire.

6. Unbox your fire and plug it in through the gap at the back of the unit before sliding it into position. You can remove the glass and use the side screws to fix the fire in place if desired. Set up your display logs/crystals to your taste.

Congratulations — you’ve just installed your new unit!